November 23 2015

Today, I finished modeling the base shoe, including the lace loops where the laces will be strung through. But I still have to work on the actual laces .

To do the lace loops, I just created a torus, scaled the Major and minor radii down accordingly. Then just placed them, and rotated them. I have them in the exact same position on both sides of the shoe, but only took screenshots of the one side. 

I also finished modeling the Ankle piece of the shoe so it fits around the tongue of the shoe, and the ankle of the leg. 

I also applied the solidify modifiers in preparation to remove all the inside faces, and so I can flatten the edges of the tongue and ankle piece 

Tomorrow, I must remove all the inside faces after I remodel the pants. Then I will add the laces to the shoe.