My process basically consists of extruding the edges, and scaling them and flattening them so it is easier to extrude later on. I started by Selecting the edge of the lips, and extruded and dragged it inside the mouth a little bit. Then did the same thing but scaled it outwards as well.
After this, I will start the next video, which shows me how to model the teeth, and also the tongue. Unless of course I get showed how to make the tongue in this video.
I tried to get a screenshot of the inside of the mouth without the wireframe, but this is the best I could do.
\
You can sort of see it through the eye hole of the model.
Tomorrow, I will continue doing what I am doing, by basically extruding it all the way down to the throat. Then if I finish that tomorrow, do some point pulling because I know I will have to. I mean, I do fix the major ones while I am modeling, I fix the minor ones afterwards because they're usually plenty of them.
No comments:
Post a Comment